Compass 2WD L4-2.0L VIN 0 (2007)
Brake Pedal Assy: Service and Repair
Removal
BRAKE PEDAL
NOTE: Refer to Warnings and Cautions.
1. Disconnect and isolate the battery negative cable from its post on the battery.
2. If equipped, remove the silencer pad below the steering column opening cover.
3. Remove the steering column opening cover on the instrument panel.
4. Remove the reinforcement behind the steering column opening cover.
5. Disconnect the wiring connector (4) at the stop lamp switch (3).
6. Remove the stop lamp switch wiring routing clip (1) from the brake pedal bracket (2).
7. Remove the stop lamp switch (2) and discard it. Do not reuse the stop lamp switch.