Compass 2WD L4-2.0L VIN 0 (2007)
3. Place the valve keepers in the retainer. Using metric valve keeper tool such as Snap-on GA317 (or equivalent) installer (2) and remover (1) as a
handle, install valve keepers with a downward push.
4. Remove air hose and install spark plugs.
5. Install valve tappets.
6. Install camshafts.
7. Install cylinder head cover.
Removal
CYLINDER HEAD OFF
1. With cylinder head removed from cylinder block, place a ball of rags in the combustion chamber.
CAUTION: Care must be taken not to damage the tappet bore or engine damage may result.
2. Mark valve tappet location for assembly.
3. Remove valve tappets.
4. Using metric valve keeper tool such as Snap-on(R) GA317 (or equivalent) remover (1), remove valve keepers with a downward push.
5. Remove retainer and springs.
6. Before removing valves, remove any burrs from valve stem lock grooves to prevent damage to the valve guides. Identify valves, locks and
retainers to insure installation in original location.
7. Inspect the valves.
Installation
CYLINDER HEAD OFF
CAUTION: Care must be taken not to damage the tappet bore or engine damage may result.
