Compass 2WD L4-2.0L VIN 0 (2007)
Hose/Line HVAC: Service and Repair
A/C Liquid Line
Removal
REMOVAL
WARNING: Review safety precautions and warnings before performing this procedure. Failure to follow the warnings and cautions could
result in possible personal injury or death.
NOTE: The A/C liquid line is only serviced as an assembly with the upper A/C suction line.
NOTE: LHD model shown in illustrations. RHD model similar.
NOTE: Illustration shown with front fascia removed for clarity.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system.
3. Raise and support the vehicle.
4. Remove the A/C accumulator.
5. Reach up through the opening in the bottom of the front fascia located in the right front corner of the vehicle and remove the nut (3) that secures
the A/C liquid line (1) to the A/C condenser (2).
6. Disconnect the A/C liquid line from the A/C condenser and remove and discard the O-ring seal and gasket.
7. Install plugs in, or tape over the opened refrigerant line fittings and the condenser and accumulator ports.
