Compass 2WD L4-2.0L VIN 0 (2007)
Cruise Control Indicator Lamp: Description and Operation
Operation
OPERATION
The cruise indicator gives an indication to the vehicle operator when the speed control system is ON, regardless of whether the speed control is engaged.
This indicator is controlled by the instrument cluster circuit board based upon cluster programming and electronic messages received by the cluster from
the Powertrain Control Module (PCM) over the Controller Area Network (CAN) data bus.
The cruise indicator is completely controlled by the instrument cluster logic circuit, and that logic will only allow this indicator to operate when the
instrument cluster receives a battery current input on the fused ignition switch output (run-start) circuit. Therefore, the indicator will always be OFF
when the ignition switch is in any position except ON or START. The indicator only illuminates when it is energized by the instrument cluster logic
circuit. The instrument cluster will turn ON the cruise indicator for the following reasons:
-
Cruise Indicator Lamp-On Message - Each time the cluster receives an electronic cruise indicator lamp-ON message from the PCM indicating
the speed control system is ON, the cruise indicator is illuminated. The indicator remains illuminated until the cluster receives a lamp-OFF
message from the PCM, or until the ignition switch is turned to the OFF position, whichever occurs first.
-
Actuator Test - Each time the cluster is put through the actuator test, the cruise indicator will be turned ON, then OFF again during the Vacuum
Fluorescent Display (VFD) portion of the test in order to confirm the functionality of the VFD and the cluster control circuitry.
The PCM continually monitors the speed control switches to determine the appropriate outputs to the speed control servo. The PCM then sends the
proper lamp-ON or lamp-OFF message to the ElectroMechanical Instrument Cluster (EMIC).
For proper diagnosis of the speed control system, the PCM, the EMIC, the CAN data bus or the electronic communication related to cruise indicator
operation a diagnostic scan tool is required. Refer to the appropriate diagnostic information.
