Compass 2WD L4-2.0L VIN 0 (2007)
NOTE: Illustration shown with front fascia removed for clarity.
11. Raise and support the vehicle.
12. Remove the tape or plugs from the liquid line fitting and the condenser port.
13. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it and a new gasket onto the liquid line fitting. Use only the specified
O-ring as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the
vehicle.
14. Reach up through the opening in the bottom of the front fascia and connect the A/C liquid line (1) to the A/C condenser (2) and install the
retaining nut (3). Tighten the nut to 5 Nm (44 in. lbs.).
15. Install the A/C accumulator.
16. Lower the vehicle.
17. Reconnect the negative battery cable.
CAUTION: Do NOT run the engine with a vacuum pump in operation or with a vacuum present within the A/C system. Failure to follow
this caution will result in serious A/C compressor damage.
18. Evacuate the refrigerant system.
19. Adjust the refrigerant oil level.
20. Charge the A/C system.
