Compass 2WD L4-2.0L VIN 0 (2007)
3. Install the ignition module (2) mounting screw (1). Tighten the screw to 2 Nm (18 in. lbs.).
NOTE: Ignition module needs to be installed on lock cylinder housing before housing installation to clear tilt lever.
4. Position the lock cylinder housing in the RUN position.
5. Align the lock cylinder housing (2) with the steering column.
6. Install the two screws (1) fastening the lock cylinder housing (2) to the column. Tighten the screws to 12 Nm (110 in. lbs.).
7. Place the actuator in the lock cylinder housing to the RUN position (if not already there).
8. Insert the key into the key cylinder and turn the key cylinder to the RUN position.
9. Align the retaining tab on the key cylinder with the slot in the top of the lock cylinder housing.
10. Slide the key cylinder into the lock cylinder housing until the key cylinder retaining tab locks the cylinder into place.
11. Rotate the key back and forth (OFF to START), then remove and reinstall it, making sure the key cylinder and lock cylinder housing operate
