Compass 2WD L4-2.0L VIN 0 (2007)
Steering Column Control Module: Service and Repair
Removal
REMOVAL
SCCM
1. Place the front road wheels in the STRAIGHT-AHEAD position.
2. Open hood.
3. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component
service. Failure to do so may result in accidental airbag deployment, personal injury or death.
4. Remove steering wheel.
5. Remove upper and lower steering column shrouds to gain access to the Steering Column Control Module (SCCM).
6. Lock the clockspring rotor in the center position as follows: Insert a grenade pin through the hole in the rotor at the 10 o'clock position.
7. Remove the three screws (1) to the Steering Column Control Module (SCCM) (3).
