Compass 2WD L4-2.0L VIN 0 (2007)
Seat Belt Height Adjuster: Service and Repair
Removal
REMOVAL
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Firmly grasp the lower end of the turning loop trim cover (2) on the upper B-pillar and pull it straight out to unsnap it from over the height adjuster
knob (1), then roll the bottom of the cover upward and pull outward to disengage the upper tab from the slot in the adjuster cover above the knob.
2. Remove the screw (3) that secures the seat belt turning loop to the height adjuster (1).
3. Remove the seat belt turning loop from the height adjuster.
4. Remove the upper trim (2) from the inside of the B-pillar (6).
5. Remove the cover (4) from over the height adjuster.
6. Remove the two screws (5) that secure the height adjuster to the inside of the B-pillar.
7. Remove the adjuster from the B-pillar.
