Compass 2WD L4-2.0L VIN 0 (2007)
4. Angle the top of the retractor into the opening in the lower inner B-pillar (1) then roll the lower end of the retractor into the opening.
5. Install and tighten the screw (6) that secures the retractor lower bracket to the base of the inner B-pillar. Tighten the screw to 40 Nm (30 ft. lbs.).
6. Position the belt web guide (5) to the B-pillar and use hand pressure to press it firmly and evenly until the two clips that secure it snap into place.
7. Route the front seat belt turning loop and lower anchor through the seat belt opening in the lower B-pillar trim (3).
8. Reinstall the lower trim onto the B-pillar.
9. Position the seat belt turning loop onto the height adjuster (2) on the upper B-pillar. Be certain that the seat belt webbing between the retractor and
the turning loop is not twisted.
10. Install and tighten the screw (4) that secures the turning loop to the height adjuster. Tighten the screw to 40 Nm (30 ft. lbs.).
11. Insert the upper tab of the turning loop trim cover (2) into the slot in the height adjuster cover above the knob on the upper B-pillar, then roll the
bottom of the cover down over the turning loop and use hand pressure to press firmly and evenly on the cover until it snaps into place.
