Compass 2WD L4-2.0L VIN 0 (2007)
Integrated Accessory Switch Assembly: Service and Repair
Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge
before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the
proper precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel from the instrument panel.
3. Disconnect the wire harness connector from the back of the instrument panel switch pod (4).
4. Remove the screws that secure the switch pod to the back of the center bezel.
5. Remove the switch pod from the center bezel.
