Compass 2WD L4-2.0L VIN 0 (2007)
Refrigerant Pressure Sensor / Switch: Service and Repair
Removal
REMOVAL
NOTE: It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.
NOTE: Typical A/C pressure transducer shown.
1. Disconnect and isolate the negative battery cable.
2. Carefully pull the top of the fascia forward to gain access to the A/C pressure transducer (2).
3. Reach down through the opening between the A/C condenser and the front fascia and disconnect the wire harness connector (1) from the A/C
pressure transducer located on the A/C discharge line (3).
4. Remove the A/C pressure transducer from the A/C discharge line and remove and discard the O-ring seal (4).
