Compass 2WD L4-2.0L VIN 0 (2007)
Hazard Warning Switch: Description and Operation
Description
DESCRIPTION
The hazard switch (4) is integral to the instrument panel switch pod (1), which is secured to the instrument panel center bezel just below the heater and
air conditioner controls. A red, stencil-like International Control and Display Symbol icon for Hazard Warning identifies the hazard switch button. The
remainder of the hazard switch circuitry is concealed within the instrument panel switch pod.
The hazard switch button has panel lamps dimmer controlled illumination for night visibility. The switch button unlatches to a slightly raised position
when the hazard warning system is activated and the icon on the switch button will illuminate at an increased intensity while the turn signals and turn
signal indicators are flashing. The switch button latches to a lowered position flush with the other push buttons in the switch pod when the hazard
warning is deactivated.
All of the circuitry and components of the hazard switch are contained within a molded black plastic instrument panel switch pod housing. A single
connector receptacle is integral to the back of the switch pod housing. The switch is connected to the vehicle electrical system through a dedicated take
out and connector of the instrument panel wire harness.
The hazard switch cannot be adjusted or repaired and, if ineffective or damaged, the entire instrument panel switch pod unit must be replaced.
