Compass 2WD L4-2.0L VIN 0 (2007)
2. While holding the cam bolt head (3) stationary, loosen the toe link mounting cam bolt nut (1).
3. Rotate the cam bolt head (3) left or right until the rear wheel toe for that rear wheel is set to the preferred specification.
4. While holding the cam bolt head (3) stationary, tighten the toe link mounting cam bolt nut (1) to 35 Nm (26 ft. lbs.).
FRONT TOE
CAUTION: Do not twist the inner tie rod-to-steering gear rubber boots while turning the inner tie rods during the front toe adjustment.
NOTE: Perform the following at each front wheel as necessary.
5. Loosen the tie rod adjusting jam nut (1). Grasp the inner tie rod (3) and rotate it one way or the other until the front wheel toe is set to the preferred
specification.
6. Tighten the tie rod adjusting jam nut to of 75 Nm (55 ft. lbs.).
7. Make sure the inner tie rod-to-steering gear rubber boot is not twisted.
