Compass 2WD L4-2.0L VIN 0 (2007)
NOTE: If equipped, make sure the wheel speed sensor mount on the rear of the hub and bearing is directed toward the front of the vehicle.
1. Position the hub and bearing on the brake support plate and trailing link.
2. Install the four bolts (1) securing the hub and bearing (2) to the trailing link. Tighten the bolts to 105 Nm (77 ft. lbs.).
3. If equipped, install the wheel speed sensor head (3) into the rear of the hub and bearing (2).
4. Install the wheel speed sensor head mounting screw (1). Tighten the screw to 10 Nm (89 in. lbs.).
