Compass 2WD L4-2.0L VIN 0 (2007)
8. Use Clutch Alignment Tool 6724 (3) to position the clutch disc (2) to the center of the flywheel (1).
9. Tighten pressure plate bolts (2) evenly and in rotation a few threads at a time The bolts must be tightened evenly and to specified torque to
avoid distorting the pressure plate.
10. Using a "criss-cross" pattern, torque pressure plate bolts (2) to 31 Nm (23 ft. lbs.). Remove the clutch disc alignment tool.
11. Apply light coat of MOPAR(R) High Temperature Bearing Grease or equivalent to clutch disc hub and splines of transmission input shaft.
CAUTION: Do not over lubricate shaft splines. This will result in grease contamination of disc.
12. Install transaxle.
GAS
