Compass 2WD L4-2.0L VIN 0 (2007)
9. Remove the nut holding the manual lever (1) to the manual shaft.
10. Remove the manual lever from the manual shaft.
CAUTION: Tilt the valve body assembly away from the transaxle case on the manual shaft side to ease removal. Pay attention to
completely remove the terminal body from the transaxle case.
11. Remove the valve body assembly from the transaxle case as follows:
a. Insert a 75 mm (3 in.) long 3 mm (0.118 in.) wide rod or wire into the linkage stopper hole of the valve body assembly to fix the pulley ratio
linkage (1).
b. Remove the bolts holding the valve body assembly to the transaxle case.
c. Remove the valve body assembly from the transaxle case.
Installation
INSTALLATION
