Compass 2WD L4-2.0L VIN 0 (2007)
Windshield Washer Spray Nozzle: Description and Operation
Description
Front
FRONT
The fluidic front washer nozzles (2) are constructed of molded plastic and include an integral check valve. Each nozzle has two integral latches (3) that
secure them in dedicated holes in the hood panel near the base of the windshield. The domed upper surface of the washer nozzle is visible on the outside
of the hood panel, and the two nozzle orifices (1) are oriented towards the windshield glass.
An integral diaphragm type check valve is contained within the body of each nozzle. The washer plumbing fittings (4) for the washer nozzles extend
below the hood panel and are accessible from the engine compartment.
The front washer nozzles cannot be adjusted or repaired and, if ineffective or damaged, they must be replaced.
Rear
REAR
The fluidic rear washer nozzle is constructed of molded plastic. The rear washer nozzle is secured by two integral latch features (1) within a mounting
hole to the right of the Center High-Mounted Stop Lamp (CHMSL) in the lower surface of the rear spoiler above the liftgate glass opening on the outer
liftgate panel.
The outer surface of the washer nozzle is visible on the lower exterior surface of the spoiler, and a rubber gasket (3) seals the nozzle to the spoiler
mounting hole. The nozzle orifice (4) is oriented downward towards the liftgate glass. The washer plumbing fitting (2) is concealed between the spoiler
and the liftgate outer panel.
The rear washer nozzle cannot be adjusted or repaired and, if ineffective or damaged, it must be replaced.
