Compass 2WD L4-24L (2008) Trunk / Liftgate Handle Removal - Service and Repair
Trunk / Liftgate Handle: Service and Repair
Installation
INSTALLATION
1. Connect the electrical connector (2).
2. Connect release cable to the handle.
3. Align handle studs to the holes in the liftgate and install handle (1).
4. Install six nuts to handle studs and tighten to 8.5 Nm (75 in. lbs.).
5. Install the lower liftgate trim (3), See: Trunk / Liftgate Interior Trim Panel/Service and Repair/Liftgate Trim Panel - Installation.