Compass 2WD L4-2.4L (2008)
Driver Seat
1. Before proceeding with the following repair procedure, review all warnings and cautions. See: Service Precautions
WARNING: Discard and replace the seat back bolts (1) with new bolts when servicing. Installing used bolts may result in the loosening of
the seat back bolts after repair. Failure to follow these instructions may result in serious or fatal injury.
2. Install the seat back assembly (2) and install the new bolts (1).
3. Tighten the bolts to 40 Nm (30 ft. lbs.).
4. Position the side shields onto the seat adjuster tabs (1) and seat the clip (2) fully.
5. Install the outer side shield screw (2).
