Compass 2WD L4-2.4L (2008)
5. Remove the inboard brake pad (5) from the caliper adapter bracket (3).
6. Remove the outboard brake pad (2) from the caliper (1) by prying the brake pad retaining clip over the raised area on the caliper. Slide the brake
pad off of the brake caliper.
Front
INSTALLATION
NOTE: Perform STEP 1 through STEP 5 on each side of the vehicle to complete pad set installation, then proceed to STEP 6.
NOTE: Make sure that the audible wear indicators (if equipped) are placed toward the top when the inboard brake pads are installed on each
side of the vehicle.
1. Place the brake pads (4, 5) in the abutment shims (3) clipped into the disc brake caliper adapter bracket (2) as shown. Place the pad with the wear
indicator attached on the inboard side (2).
2. Completely retract the caliper piston back into the bore of the caliper.
