Compass 2WD L4-2.4L (2008)
3. Lubricate the reservoir mounting area with fresh clean brake fluid. Place the reservoir (1) in position over the grommet seals in the master cylinder
(2). Slide the reservoir into the grommet seals by firmly pressing down on the fluid reservoir. Once installed, make sure fluid reservoir is touching
the top of both grommet seals.
4. Install the fluid reservoir mounting screw (3). Tighten the screw to 5.5 Nm (48 in. lbs.).
5. Thoroughly bleed the master cylinder before installing it. See: Procedures
6. Install the master cylinder. See: Removal and Replacement/Master Cylinder - Installation
