Compass 2WD L4-2.4L (2008)
7. Install the tire and wheel assembly (1) See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels -
Installation. Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
8. Lower the vehicle.
9. Block the tire and wheel assemblies so the vehicle does not move with the vehicle parking brake lever released.
10. Ensure that the seal grommet on the cable installed from underneath is fully seated into the floor pan.
11. Route the parking brake cable under the carpeting, up to the parking brake cable retaining bracket (4) on the floor pan. Insert the parking brake
cable (3) through the retaining bracket. Push the cable in until the locking fingers on the cable retainer lock the cable into place.
CAUTION: A NEW parking brake cable equalizer (2) must be installed when servicing the parking brake cables or lever. The equalizer has an
integrated bent nail tensioner that needs to be stretched upon installation placing the correct tension on the cables.
12. Remove and install a NEW parking brake cable equalizer (2) on the parking brake lever output cable.
13. Install the rear parking brake cables (3) into the equalizer (2) on the parking brake lever output cable.
