Compass 2WD L4-2.4L (2008)
NOTE: If piston/connecting rod replacement is necessary, remove cylinder head See: Cylinder Head Assembly/Service and Repair/Removal
and Replacement/Cylinder Head - Removal.
CAUTION: DO NOT use a number stamp or a punch to mark connecting rods. Damage to connecting rod could occur.
18. Using a permanent ink or paint marker, identify cylinder number on each connecting rod and cap.
19. Remove all connecting rod bolts and caps. Care should be taken not to damage the fracture rod and cap surfaces.
NOTE: Do not reuse connecting rod bolts.
20. Remove main bearing caps.
CAUTION: Use extreme care when handling crankshaft. Tone wheel damage can occur if crankshaft is mis-handled.
21. Lift out crankshaft from cylinder block. Do not damage the main bearings or journals when removing the crankshaft.
Crankshaft - Installation
INSTALLATION
