Compass 2WD L4-2.4L (2008)
10. Install the bolt (1) that secures the A/C liquid and suction line assembly to the A/C evaporator. Tighten the bolt to 12 Nm (105 in. lbs.).
11. Position the heat shield (3) onto the studs (2) located on the dash panel in the engine compartment.
12. Install the three nuts (1) that secure the heat shield to the dash panel. Tighten the nuts to 1 Nm (10 in. lbs.).
13. Reconnect the negative battery cable.
14. If the heater core is being replaced, flush the cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
15. Refill the engine cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
16. Evacuate the refrigerant system See: Service and Repair/Refrigerant System Evacuate.
17. Charge the refrigerant system See: Service and Repair/Refrigerant System Charge.
