Compass 2WD L4-2.4L (2008)
2. Install the power steering pressure hose into the engine compartment from below.
3. Install the pressure hose at the gear. Tighten the tube nut (2) to 32 Nm (24 ft. lbs.).
4. Lower the vehicle.
5. Install the pressure hose (3) at the pump pressure port (5). Tighten the tube nut to 32 Nm (24 ft. lbs.).
6. Install the pressure hose routing bracket bolt (2) to the upper mount (8).
7. Fill and bleed the power steering system. See: Steering and Suspension/Steering/Power Steering/Power Steering Bleeding/Service and Repair
8. Check for leaks.
9. Install the engine appearance cover.
Return Hose
INSTALLATION
