Compass 2WD L4-2.4L (2008)
Battery Cable: Service and Repair
Battery Cables - Installation
INSTALLATION
1. Position the battery cables in the engine compartment.
2. One at a time, install the battery cable retaining pushpins, fasteners and routing clips until the cables are installed exactly where they were in the
vehicle.
3. Connect the battery cable to the B+ terminal of the starter motor. Tighten the cable nut to 13 Nm (115 in. lbs.).
4. Connect the battery cable to the B+ terminal of the generator. Tighten the cable nut to 14 Nm (125 in. lbs.).
5. Install the nut (1) securing the negative cable (2) to the body ground stud. Tighten the cable nut to 12 Nm (9 ft. lbs.).