Compass 2WD L4-2.4L (2008)
Control Arm: Service and Repair
Removal
REMOVAL
1. Raise and support the vehicle. See: Maintenance
2. Remove the bolt (2) securing the toe link (3) to the trailing link.
3. Mark the position of the cam bolt cam on the crossmember using a paint marker or crayon. This mark will be used upon installation to help get the
alignment close prior to performing rear wheel alignment. Do not use any type marker that will scratch or damage the surface of the crossmember.
4. While holding the cam bolt head (3) stationary, loosen and remove the toe link mounting cam bolt nut (1) and washer. Remove the cam bolt.
