Compass 2WD L4-2.4L (2008)
5. Remove the clamp (if installed) from the bottom of the coil spring and remove the strut (damper) (8) out through the bottom of the coil spring. The
dust shield and jounce bumper will come out with the strut.
6. Remove the lower spring isolator (7) from the strut seat.
7. Slide the dust shield and jounce bumper (6) from the strut rod.
8. Remove the upper mount (2) and bearing (3) from the top of the upper spring seat and isolator (4).
9. Remove the upper spring seat and isolator (4) from the top of the coil spring (5).
NOTE: If the coil spring needs to be serviced, proceed with the next step, otherwise, proceed with STEP 11.
10. Release the tension from the coil spring by backing off the compressor drive completely. Push back the compressor hooks and remove the coil
spring.
11. Inspect the strut assembly components for the following and replace as necessary:
-
Inspect the strut (damper) (8) for shaft binding over the full stroke of the shaft.
-
Inspect the jounce bumper (with dust shield) (6) for cracks and signs of deterioration.
-
Check the upper mount (2) for cracks and distortion and its retaining studs for any sign of damage.
-
Check the bearing (3) for any binding.
-
Check the upper spring seat and isolator (4) for cracks and distortion.
