Compass 2WD L4-2.4L (2008)
6. Install the lower spring isolator (12) on the spring seat of the shock absorber (13).
7. Slide the dust shield (10), jounce bumper (9) and washer (8) onto the shock rod.
8. Install the shock absorber (13) up through the bottom of the coil spring and upper mounting bracket until the lower spring seat contacts the lower
end of the coil spring.
9. While holding the shock absorber in position, install the washer (2) and nut (1) on the end of the shock rod.
CAUTION: Never use impact or high speed tools to remove the shock rod nut. Damage to the shock internal bearings can occur.
10. Install Snap-On(R) Shock Absorber Socket A139, or equivalent, on the end of the shock rod (1). While holding the shock rod from turning, tighten
the nut (2) using a crows foot wrench and a torque wrench. Tighten the shock rod nut to 24 Nm (18 ft. lbs.).
