Compass 2WD L4-2.4L (2008)
7. Install a NEW snap ring (2) in the knuckle using an appropriate pair of snap ring pliers (1). Make sure the snap ring is fully seated.
8. Place the knuckle in an arbor press. Support the knuckle from underneath using Remover/Installer (3), Special Tool MB-990799, smaller end up
against the wheel bearing inner race.
9. Place the hub (4) in the wheel bearing making sure it is square with the bearing inner race.
10. Position Remover/Installer, Special Tool 9712-2 (2), in the end of the hub. Lower the arbor press ram (1) and press the hub into the wheel bearing
until it bottoms.
11. Remove the knuckle and tools from the press.
12. Verify the hub turns smoothly without rubbing or binding.
13. Install the knuckle on the vehicle. See: Front Steering Knuckle/Service and Repair/Front Steering Knuckle - Installation
