Compass 2WD L4-2.4L (2008)
NOTE: Typical primer installation shown.
5. Clean and dry area of glass (2) to be re-glued with a suitable glass preparation solvent and rag.
6. Using a flash light, verify that glass primer is without damage.
7. Re-prime any damaged area. If old adhesive has been exposed for more than 12 hours, entire adhesive area needs to be re-primed.
8. Apply primer (1) around the perimeter of the glass to a width of 15 mm (0.5 in.) (2).
9. Allow primer to air dry for at least 10 minutes.
10. Using a flash light, verify that glass primer is without damage.
Glass Preparation - Installing A New liftgate glass
1. Apply two new spacers (2) to the liftgate frame.
2. Install the lower spacers to the liftgate horizontal flange.
