Compass 2WD L4-2.4L (2008)
NOTE: Typical primer installation shown.
1. Clean and dry area of glass (2) to be re-glued with a suitable glass preparation solvent and rag.
2. Apply primer to gluing surface at quarter glass seal.
3. Apply primer (1) around the perimeter of the glass to a width of 15 mm (0.5 in.).
4. Allow primer to air dry for at least 10 minutes.
5. Using a flash light, verify that glass primer is without damage.
Quarter Glass Opening Preparation
NOTE: Windshield opening shown, quarter glass opening similar.
1. Clean and vacuum quarter glass opening.
2. Level old bead of quarter glass opening adhesive (1) to a thickness of approximately 1 mm (0.04 in.) and remove loose adhesive.
NOTE: Windshield opening shown, quarter glass opening similar.
3. Clean and dry area of quarter glass opening to be re-glued with a suitable glass preparation solvent and rag.
4. Re-prime any damaged area. If old adhesive has been exposed for more than 12 hours, entire adhesive area needs to be re-primed.
5. Allow primer to air dry for at least 10 minutes.
Quarter Glass Installation
