Compass 2WD L4-2.4L (2008)
Rear Door Window Regulator: Service and Repair
Rear Door Window Regulator - Installation
INSTALLATION
1. Position the regulator assembly onto the door trim panel (1) and seat the runner support clips (3) fully.
2. Connect the regulator motor electrical connector, if equipped.
3. Install the lower regulator screw (2) but do not tighten them at this time.
4. Install the door trim module (1), See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front
Door Module Trim - Installation.
