Remove Vehicle Theft Security Siren - Remove
Alarm Horn: Service and Repair
Vehicle Theft Security Siren - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the splash shield from the right front wheel house. See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and
Repair/Splash Shield - Removal.
3. Locate the alarm siren module (1) on the outboard side of the right front fender load path beam (4).
4. Disconnect the engine compartment wire harness connector (5) from the connector receptacle near the back of the siren.
5. Remove the two screws (2) that secure the siren mounting bracket to the load path beam.
6. Remove the siren and mounting bracket from the load path beam as a unit.