Compass 4WD L4-2.0L (2009)
Throttle Body: Service and Repair
Throttle Body - Removal
REMOVAL
WARNING: DO NOT place fingers in or around the throttle body plate. If the throttle body is energized, the throttle plate could move causing
personal injury. Always disconnect the negative battery cable prior to servicing the throttle body.
CAUTION: DO NOT move the throttle plate while power is connected to the throttle body. This may cause fault codes to set.
1. Disconnect and isolate negative battery cable at battery.
2. Remove throttle body air intake hose.
3. Disconnect throttle body electrical connector (1) from throttle body (2).
4. Remove throttle body support bracket bolt (2).
5. Remove four bolts (1), throttle body bracket (3) and throttle body (4) from the intake manifold.
