Compass 4WD L4-2.4L VIN W (2007)
b.
PM: 1 in regulator, 2 in window motor brace and 1 in door module.
13.
Disconnect linkage(s) at latch to:
a.
MK49 - Compass 1). Outside door handle and 2). Fulcrum.
b.
MK74 - Patriot and PM - Caliber Outside door handle.
14.
Remove (3) screws, (T-30 Torx), retaining latch to door.
15.
Maneuver door module up, then forward, then down to remove from door.
16.
Place removed door module face down on a clean, protected surface.
17.
Follow specific instructions based on vehicle below:
a.
MK: Remove wiring and convolute tubing from retainers and wrap with Open Cell Foam Tape, (p/n 05019057AA) in the areas described in
below. Any wiring or convoluted tubing that is not wrapped or can come in contact with the door module shell should be wrapped with foam
tape as shown in (Fig. 6) below. Reinstall wiring and convolute tubing back in retainers.
