Compass 4WD L4-2.4L VIN W (2007)
NOTE:
Be sure mirror wiring protrudes through opening in top of door module.
26.
Start, (do not tighten), all remaining bolts for door module and window regulators. Once all bolts are loosely installed, tighten all bolts to 8 N.m
(71 in. lbs.)
27.
Install door latch screws, (T-30 Torx), Tighten to 7 N.m (62 in. lbs.).
28.
Connect linkage(s) to door latch mechanism.
29.
Position wire harness door bracket at front of door and install screws, (5 mm hex). Install weatherstrip.
30.
Connect wire harness to body from door.
31.
Connect mirror wire harness, (if equipped) and install trim flag.
32.
Install screw, (T-20 Torx), at inner door handle and replace trim.
33.
Install door glass making sure glass clips into regulator securely.
34.
Install door bolster trim panel.
35.
Install screw, (T-20 Torx), and trim cap at door pull cup.
36.
Install manual window crank handle, (if equipped).
37.
Install speaker screws, (T-20 Torx), and speaker grille.
38.
Clean glass.
39.
Repeat this process for other front door.
REAR DOOR REPAIR PROCEDURE:
1.
Pull weatherstrip off front of door at wire harness bracket entering door. Remove 2 bolts, (5 mm hex) at wire harness door bracket. Disconnect
wire harness from body of vehicle.
2.
Remove trim cap and screw, (T-20 Torx), at inside door handle.
3.
Remove manual window crank handle, (if equipped).
4.
Using trim stick, remove speaker cover.
5.
Remove top front and lower rear speaker screws only. (Speaker will remain with door module).
6.
Remove bolt(s), (10 mm hex), retaining door module near speaker.
a.
MK: 2 bolts
b.
PM: 1 bolt
7.
Remove (1) longer bolt, (10 mm hex), retaining door module and window regulator at bottom of door module.
8.
Remove trim cap and screw, (1-20 Torx), at inside door pull cup.
9.
Using trim stick, release bolster, swing down and allow to hang by tethers.
10.
Release window latch retainer at bottom of glass from regulator.
11.
Slide glass up in frame and duct tape from outside of window, up over frame to inside of window in the full UP position.
12.
Remove bolts, (10 mm hex) behind bolster:
a.
MK: 2 in regulator and 1 at center of door module.
