Compass 4WD L4-2.4L VIN W (2007)
Liftgate Opening Preparation
NOTE: Windshield opening shown, liftgate opening similar.
1. Clean and vacuum liftgate opening.
2. Level old bead of liftgate opening adhesive (1) to a thickness of approximately 1 mm (0.04 in.) and remove loose adhesive.
NOTE: Windshield opening shown, liftgate opening similar.
3. Clean and dry area of liftgate opening to be re-glued with a suitable glass preparation solvent and rag.
4. Re-prime any damaged area. If old adhesive has been exposed for more than 12 hours, entire adhesive area needs to be re-primed.
5. Allow primer to air dry for at least 10 minutes.
liftgate glass Installation
