Compass 4WD L4-2.4L VIN W (2007)
License Plate Frame: All Technical Service Bulletins
Body - Rear License Plate Bracket Rattling
NUMBER: 23-027-07
GROUP: Body
DATE: July 11, 2007
SUBJECT:
License Plate Rattle
OVERVIEW:
This bulletin involves checking the proper position of the isolation foam tape on the liftgate and if an aftermarket plate frame is installed, isolating the
frame to prevent rattle sounds.
MODELS:
2007 - 2008
(MK)
Compass/Patriot
2007 - 2008
(PM)
Caliber
SYMPTOM/CONDITION:
Vehicle operator may experience a rattle sound from the liftgate caused by the license plate or aftermarket Dealer Installed plate frame or bracket.
DIAGNOSIS:
Perform a liftgate "slam test to verify the rattle is originating from the license plate or plate frame/bracket. If it is determined that the sound is being
caused by the plate or plate frame, perform the Repair Procedure.
PARTS REQUIRED:
REPAIR PROCEDURE:
1.
With chalk or tape, mark the 2 lower corners of the license plate.
2.
Remove the license plate and plate frame, (if equipped).
3.
Inspect to determine if foam blocks were installed on the liftgate at a location that would match the lower corners of the License Plate.
4.
Are the Foam Blocks Located at the lower outer corner locations:
a.
Yes - Continue with Isolating the Aftermarket Frame (if equipped). If a plate frame is not installed, further diagnosis will be required to
determine the rattle source.
b.
No - Continue with the repair.
5.
Clean the liftgate in the area of the LOWER corners of the license plate with alcohol wipe or equivalent.
6.
Cut 2 squares of Closed Cell Low Density Foam Tape p/n 05019058AA into .625 in (15 mm) x .625 in (15 mm) blocks.
