Compass 4WD L4-2.4L VIN W (2007)
NOTE: When installing the sensor head to the spring-loaded retainer on the hub and bearing, make sure the head is held snug in the retainer.
If there is any play, the clip is deformed and the hub and bearing must be replaced. The retainer is not serviced separately.
1. Clip the wheel speed sensor head (1) (flat side to bearing rear face) into the spring-loaded retainer on the rear of the hub and bearing (2).
2. Position the wheel speed sensor (3) on the trailing link (2) and install the screw (4) securing it in place. Tighten the mounting screw to 18 Nm (13
ft. lbs.).
3. Position the wheel speed sensor (3) and install the routing clip (1) fastening the sensor to the trailing link (2).
4. Position the wheel speed sensor cable routing clamp (3) on the rear suspension crossmember (4) and install the mounting screw (1). Tighten the
mounting screw to 18 Nm (13 ft. lbs.).