Compass 4WD L4-2.4L VIN W (2007)
12.
Inspect the rear of the # 1 camshaft bearing cap at the exhaust camshaft (Figure 1):
If the split line of the bearings and the split line of the bearing cap-to-cylinder head are parallel to each other, continue with Step 13.
If the split line of the bearings and the split line of the bearing cap-to-cylinder head are NOT parallel to each other, (the bearing has rotated)
contact the STAR Center for further assistance.
13.
Tighten each of the front camshaft bearing cap bolts to 20 ft.lbs. (27 N.m) in the following order (Figure 2):
a.
Exhaust side outside bolt (1).
b.
Intake side outside bolt (2).
