Compass 4WD L4-2.4L VIN W (2007)
Water Pump: Removal and Replacement
Removal
GAS ENGINE
1. Remove the accessory drive belt.
2. Drain engine coolant.
3. Raise vehicle.
4. Remove accessory drive belt splash shield.
5. Drain cooling system.
6. Remove screws attaching water pump pulley (1). Remove pulley (1).
7. Remove water pump mounting bolts (2).
8. Remove water pump (3).
Installation
GAS ENGINE
1. Position water pump assembly (3) into water pump housing (4).
2. Install mounting bolts (2). Tighten bolts to 24 Nm (212 in. lbs.).
3. Install water pump pulley (1). Tighten bolts to 9 Nm ( 80 in lbs.).
4. Install drive belt splash shield.
5. Lower vehicle.
6. Install accessory drive belt.
7. Connect battery negative terminal.
8. Fill cooling system.