Compass 4WD L4-2.4L VIN W (2007)
9. Install the blend door pivot lever (3) onto the end of the blend door pivot shaft (4) located on the left side of the air distribution housing (2). Make
sure the lever retaining tab is fully engaged to the pivot shaft.
NOTE: Align the pin on the blend door lever with the groove in the pivot lever prior to installation of the blend door lever.
10. Install the blend door lever (6) onto the air distribution housing. Make sure the levers are correctly aligned to each other.
11. Install the screw and washer (5) that secure the blend door lever to the air distribution housing. Tighten the screw to 0.6 Nm (5 in. lbs.).
12. Install the temperature control cable (1).
13. If equipped with the 2.0L diesel engine, install the electric positive temperature coefficient (PTC) heater unit into the air distribution housing.
14. Install the heater core into the air distribution housing (2).
15. Install the air distribution housing onto the HVAC housing (1).
16. Install the HVAC housing assembly.
Air Inlet Housing
HOUSING-AIR INLET
NOTE: LHD model with A/C shown in illustrations. RHD and heater-only models similar.
