Compass 4WD L4-2.4L VIN W (2007)
3. Firmly grasp the position lamp socket and rotate it counterclockwise about 30 degrees to unlock it.
4. Pull the socket and bulb straight out from the keyed opening in the housing.
5. Pull the base of the bulb straight out of the socket.
Bulb - Headlamp - Domestic
BULB - HEADLAMP - DOMESTIC
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
1. Align the headlamp bulb base (3) with the keyed opening on the back of the headlamp reflector (2).
2. Insert the bulb and base into the reflector until the base is firmly seated.
3. Using the tabs on each side of the connector receptacle, rotate the bulb base clockwise about 30 degrees to lock it into place.
4. Reconnect the engine compartment wire harness connector to the connector receptacle integral to the bulb base on the back of the headlamp unit
housing (1).
5. Reconnect the battery negative cable.
Bulb - Position Lamp
BULB - POSITION LAMP
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The following procedure applies only to vehicles manufactured for export markets. Vehicles manufactured for domestic markets do not have a
position lamp bulb, socket or wiring provided in the headlamp unit.
