Compass 4WD L4-2.4L VIN W (2007)
10. Remove the tape or plugs from the discharge line fitting and the compressor port.
11. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it and a new gasket onto the discharge line fitting. Use only the specified
O-ring as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the
vehicle.
12. Connect the A/C discharge line (2) to the A/C compressor (3).
13. Install the nut (1) that secures the A/C discharge line to the A/C compressor. Tighten the nut to 20 Nm (15 ft. lbs.).
14. Install the splash shield onto the right side frame rail.
15. Lower the vehicle.
16. Reconnect the negative battery cable.
CAUTION: Do NOT run the engine with a vacuum pump in operation or with a vacuum present within the A/C system. Failure to follow
this caution will result in serious A/C compressor damage.
17. Evacuate the refrigerant system.
18. Adjust the refrigerant oil level.
19. Charge the refrigerant system.
