Compass 4WD L4-2.4L VIN W (2007)
2. Insert the sensor (1) through the wheel (2) as shown keeping pressure against the rear of the metal valve stem (See Arrow). The potted side of the
sensor is to be positioned toward the wheel. Do not attempt to mount the sensor otherwise, damage may occur.
3. Install the sensor nut (with pressed-in washer) (3) by hand.
NOTE: Before tightening the sensor nut, push downward on the sensor housing (2) in an attempt to make it flush with the interior
contour of the wheel (1).
4. While holding the sensor in position, tighten the sensor nut to 6.5 Nm (58 in. lbs.).
CAUTION: Over-torquing the sensor nut by as little as 12 Nm (106 in. lbs.) may result in sensor separation from the valve stem. Under
this condition, the sensor may still function. However, the condition should be corrected immediately.
5. Mount the tire on the wheel following the tire changer manufacturers instructions, paying special attention to the following to avoid damaging tire
pressure sensor:
a.
