Compass 4WD L4-2.4L VIN W (2007)
Power Distribution Module: Service and Repair
Module-Inverter
Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
1. Disconnect and isolate the negative battery cable.
2. Remove the shift bezel.
3. Remove the center bezel from the instrument panel.
4. Remove the fasteners from the mounting brackets of the inverter module.
5. Disconnect the electrical connectors and remove the inverter module.
Installation
INSTALLATION
1. Connect the electrical connectors to the inverter module.
2. Install the fasteners to the mounting brackets.