Compass 4WD L4-2.4L VIN W (2007)
>
If the date code is not legible, replace the accelerator pedal. Continue with Step 7 of this procedure.
7. Connect the accelerator pedal electrical connector to the new accelerator pedal or original accelerator pedal (depending on inspection results).
8. Install the accelerator pedal into the vehicle and tighten the mounting nuts to 22 ft. lbs. (30 N.m) in the sequence shown in Figure 4.
9. Connect the negative battery cable.
10. On vehicles that had the original accelerator pedal installed, no further action is required. On vehicles that had the accelerator pedal replaced,
continue with Step 11.
11. Use one of the following scan tools and related procedure to perform the "Learn ETC" procedure:
Using wiTECH:
a. Connect the wiPOD to the vehicle data link connector.
b. Place the ignition key in the "RUN" position.
c. Launch the wiTECH diagnostic application.
d. Select "PCM" from the vehicle view screen.
e. Select the "MISC FUNCTION" tab.
f.
Select "Learn ETC" from the list.
g. Follow the screen prompts.
h. Clear all DTC's.
NOTE:
Due to the "Learn ETC" procedure, DTC(s) may be set in other modules (PCM, TCM, ABS, BCM, MIC, WCM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate.
i.
Place the ignition in the "OFF" position, remove the wiPOD from the data link connector
Using StarMOBILE:
a. Connect the StarMOBILE scan tool to the vehicle data link connector located under the steering column and turn the ignition key to the "RUN"
position.
b. Connect the CH9410 StarMOBILE scan tool ethernet cable to the StarMOBILE and the dealer's network drop.
c. Power ON the StarMOBILE scan tool.
d. From the desktop, launch the "StarMOBILE Desktop Client" software.
