Compass 4WD L4-2.4L VIN W (2007)
**Verify that the oil pressure meets specifications as listed in DealerCONNECT > TechCONNECT. If the oil pressure does not meet specifications, the
OCV will be unable to function properly. In this case, further diagnosis will be required to determine the cause of inappropriate oil pressure.**
**If the Oil Pressure meets specifications, DTC's are present and cannot be duplicated, perform the Repair Procedure**.
PARTS REQUIRED:
SPECIAL TOOLS / EQUIPMENT REQUIRED:
FLASH REPAIR PROCEDURE - USING THE INTERNET TO RETRIEVE THE FLASH
FILE:
CAUTION:
DO NOT START THE ENGINE PRIOR TO COMPLETING STEP 5n and/or 8h. IF THE PROCEDURE IS NOT ADHERED TO THE
CONTROLLERS MAY NOT COMPLETE THE PROGRAMMING PROCESS.
NOTE:
When performing this Repair Procedure, the software release level in the StarSCAN(R); must be programmed with 7.04 SP1 software or higher. The
software release level is visible in the blue header at the top of the StarSCAN(R) screen.
NOTE:
The StarSCAN(R) diagnostic scan tool fully supports Internet connectivity. However, to take advantage of this feature you must first configure the
StarSCAN(R) for your dealership's network. Make sure the StarSCAN(R) is configured to the dealership's network before proceeding. For
instruction on setting up your StarSCAN(R) for the dealer's network refer to either:
"DealerCONNECT > Service > StarSCAN and StarMOBILE tools > Online Documentation", or refer to the StarSCAN® Quick Start Networking
Guide.
The StarSCAN(R) Quick Start Networking Guide is also available on the website under the "Download Center".
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted.
1.
Install a battery charger and verify that the charging rate provides approximately 13.5 volts. Set the battery charger to continuous charge. Do not
allow the charger to time out during the flash process. Remove the charger from the battery when the flash process is complete.
2.
Connect the CH9410 StarSCAN® ethernet cable to the StarSCAN(R) and the dealer's network drop.
3.
Connect the CH9404 StarSCAN(R) vehicle cable to the StarSCAN(R) and the vehicle.
