Compass 4WD L4-2.4L VIN W (2007)
Oxygen Sensor: Service and Repair
Installation
1/1 Upstream - 2.0/2.4L
1/1 UPSTREAM - 2.0/2.4L
1. After removing the sensor, the exhaust manifold threads must be cleaned with an 18 mm X 1.5 + 6E tap. If reusing the original sensor, coat the
sensor threads with an anti-seize compound such as Loctite(R) 771-64 or equivalent. New sensors have compound on the threads and do not
require an additional coating. Tighten the sensor to 41 Nm (30 ft. lbs.).
2. Install sensor using an oxygen sensor crow foot wrench such as Snap-On tool YA8875 or equivalent.